Medela Solo Instrucciones De Uso página 9

Before first use, remove and dispose of the protective cover ( ¢4-01) from the breast shield
( ¢4-02). Wash and sanitise the pump set and bottles following the steps 1 to 4 below before
using them for the first time. Wash your pump set and bottles after each use and sanitise the
parts once per day after they have been washed.
1. Disassemble
Refer to figure ¢1 on the foldout page.
i. Disassemble the pump set into its individual parts (breast shield, connector and bottle).
ii. Open the connector ( ¢1-01) by squeezing both flaps and swivelling the lid upwards and remove the
membrane ( ¢1-02).
iii. Separate the bottles, lids and bottle stands.
2. Wash (before first use and after each use)
Rinse and wash by hand
i. Rinse the disassembled parts, except for the
tubing, with cool water (approx. 20 °C).
ii. Clean these parts with plenty of warm,
soapy water (approx. 30 °C). Use a commer-
cially available washing-up liquid.
iii. Rinse the parts with cool water for 10 to 15
seconds (approx. 20 °C).
3. Sanitise (before first use and once per day)
Sanitise on stovetop
Cover the disassembled, washed parts, except
for the tubing, with water and boil at least for
5 minutes.
4. Dry
Allow to air-dry on a clean, unused dish towel or paper towel. Store the dry parts in a clean environment.
Do not store parts in an airtight container/bag if moist. It is important that all residual moisture dries.
or
or
5 min
Wash in dishwasher
Place the disassembled parts, except for the
tubing, on the top rack or in the cutlery section.
Use a commercially available dishwashing
detergent.
Sanitise in microwave
Use Quick Clean* bags in the microwave in
accordance with the instructions on the bags.
* Refer to local website/shops for availability in
your country.
9