How To Use - Dreame Bot Z10 Pro Manual Del Usuario

How to Use

EN
1. Turn On/Off
Press and hold the button for 3 seconds to turn on the robot. Once the
power indicator turns solid white, the robot is on standby. To turn off the
robot, press and hold the button for 3 seconds when the robot is not
moving.
2. Start Cleaning
Press the button briefly to turn on the robot. Upon activation, the robot
will accurately map out a route, methodically clean along the edges and
walls, then finish by cleaning each room in an S-shaped pattern to ensure
a thorough job.
3. Cleaning Mode
Dreame Bot Z10 Pro has four cleaning modes: Quiet, Standard, Strong, and
Turbo. The default mode is Standard. You can specify the cleaning mode in
the Mi Home/Xiaomi Home app.
12
4. Pause/Sleep Mode
Pause: Press any button briefly to pause the robot during cleaning.
Sleep Mode: The robot will automatically enter Sleep Mode after 10
minutes of inactivity, then the power indicator and charging indicator will
go off. To wake up the robot, press any button.
Note:
• The robot will turn off automatically if left in Sleep Mode for more than 12 hours.
• When the robot is paused, placing it onto the base will end the current cleaning
task.
5. Spot Clean Mode
When the robot is paused or in Standby Mode, press and hold the button
3 seconds to start Spot Clean Mode. In this mode, it will clean a square-shaped
area of 1.5×1.5 meters directly around the robot. When the spot cleaning is
done, the robot will automatically return to its original location and power off.
Note: Activating Spot Clean Mode will end the current cleaning task of the robot.
6. Additional App Functions
You can enable more functions via Mi Home/Xiaomi Home app such as
selected room cleaning, zone cleaning, forbidden area/virtual no-go
zones, etc.
Note:
• Follow the instructions on the app interface to use more functions.
• The version of the app might have been updated; please follow the instructions
based in the current app version.
How to Use
7. Use the Mopping Function
It is recommended that all floors are vacuumed at least three times before
the first mopping session to achieve a better cleaning effect.
1) Dampen the mop pad and wring out excess water. Insert the mop pad into
the slot of the water tank as shown in the figure, and paste the pad firmly.
for
① ②
2) Open the water tank lid, fill the tank with water, then securely close the lid.
Note: Do not use detergent or disinfectant.
3) Align the mopping module as indicated by the arrow, then slide it into the
back of the robot until it clicks into place. Press the button
Home/Xiaomi Home app to start cleaning.
Click
Click
Note:
• It is not recommended to use the mopping function on carpets.
③
• Use the app to adjust the water flow as required.
4) Press the two side clips inwards and slide the water tank backwards to
separate it from the robot.
Note: When the robot is charging or not in use, remove the mopping module,
pour out all the remaining water in the tank, and clean the mop pad to prevent
mildew or odors.
EN
or use the Mi
13