Controlling The Volume - Bowers & Wilkins Zeppelin Manual De Instrucciones

Controlling the volume

There are three ways to adjust Zeppelin's volume.
If your iPod/iPhone is docked, and it is a Group
D or Group E device, its own volume control can be
used to alter Zeppelin's volume level, which is also
displayed on the iPod/iPhone's screen.
For the touch screen of devices in Group E,
use the slider volume control at the bottom of the
screen. For Group D iPods, use the click wheel.
When using the volume control of a docked
iPod/iPhone, its own internal volume level is not
affected, but is retained at its original level for
when you remove the iPod/iPhone and go back
to using headphones.
The click wheel and display of Group B and
Group C iPods will not function in this way.
–
–
On Zeppelin itself, press on the upper section of
the long button, marked + to increase the volume
and the lower section, marked - to decrease it
On the remote, press the + button to increase
the volume and the - button to decrease it.
In both cases, a short press will make a small
change, or you can press and hold to ramp up or
down.
+
+
As you alter the volume level, Zeppelin's LED will
flash. As you approach the maximum level, the LED
will turn white. Once you reach either the maximum
or minimum level, the LED will turn red.
9