Master MCO Manual De Uso Y Mantenimiento página 21

Place the two side protectors (C) as shown in the following image.
6
Secure them with a No. 6 hex key and the DIN 7380 M8x16 bolts
(G), the DIN 125 M8 washers (J) and the M8 hammerhead nuts (M).
Place the electrical box as shown in the following image and secure it with the help of a No. 5 hex key, the DIN 7380 M6x10 bolts (H) and
8
the DIN 125 M6 washers (K) to the threaded holes of the aluminium profile. IMPORTANT: Place the electrical box on the leg adjacent to the
motor.
Connect the electrical box to the motor.
9
Next, connect one end of the power cable (O) to the connector in the electrical box of the conveyor belt, and the other end to the electricity
11
supply.
IMPORTANT: Make sure that the electrical wiring is perfectly positioned, without forming loops that could cause tripping.
Place the front protector (D) at the end of the conveyor as shown
7
in the following image. Fasten the DIN 7380 M4x10 bolts (I), the
DIN 125 M4 washers (L) and the DIN 985 M4 self-locking nuts (N)
with the help of a No. 2.5 hex key and a No.7 fixed spanner.
Place the conveyor belt adjacent to the bud trimming machine.
10
These should be placed next to each other keeping a slight space
between them. IMPORTANT: Not leaving a safety margin could
cause rubbing and possible damage to the items.
www.masterproducts.es
21