Master MCO Manual De Uso Y Mantenimiento página 24

Using a No. 10 spanner, loosen the tensioning screw on both sides
6
until it does not touch the head.
8 Remove the two heads carefully.
Remove the conveyor band and proceed with the general cleaning of the equipment and components.
10
Firstly, manually remove the largest remains of dirt and/raw materials present on the machine and its components.
Then wash all components and the machine in general with a pressure sprayer or hose. Water is one of the two most
important cleaning agents. It should be used to remove 60% to 70% of all foreign matter left on your conveyor machine.
To best dissolve dirt, keep the water temperature between 32-57 °C.
Finally, to complete the cleaning, spray the equipment and its components with Master Clean. Do not use detergents
or other cleaning products not specified by the manufacturer. Let Master Clean act for several seconds and then
remove it only with the help of paper.
24
Identify the two heads of the drive roller. Loosen the four
7
securing bolts with a No. 6 hex key.
9
Remove the drive roller.
www.masterproducts.es