Troubleshooting; Dismounting; Disposal; Materials - Abicor Binzel WH Instructivo De Servicio

8 Troubleshooting

8 Troubleshooting
NOTE
• If the measures described below are not successful, please consult your dealer or the manufacturer.
• Please also consult the operating instructions for the welding components, such as the power supply,
Fault
The test block is blocked and
does not return automatically to
the basic position
The torch does not fit into the
clamping device
Tab. 7

9 Dismounting

Dismounting may only be carried out by specialized personnel. Please make sure that the shutdown
procedures are strictly observed before the dismounting is started. Observe it also for the components
integrated into the welding system.

10 Disposal

For the disposal observe the local regulations, laws, provisions, standards and guidelines. For the product
to be disposed of properly, it must be dismounted, first.
 See 9 Dismounting on page EN-10

10.1 Materials

This product is mainly made of metallic materials which can be melted in steel and iron works and are, thus,
almost infinitely recyclable. The plastic materials used are marked in preparation for sorting and separation
of the materials for later recycling.

10.2 Consumables

Oil, grease and cleaning agents must not contaminate the ground or enter sewage systems. These materials
must be stored, transported and disposed of in suitable containers. Observe the relevant local regulations
and disposal instructions of the safety data sheets specified by the manufacturer of the consumables.
Contaminated cleaning tools (brushes, rags, etc.) must also be disposed of in accordance with the
information provided by the manufacturer of the consumables.

10.3 Packaging

ABICOR BINZEL has reduced the packaging for shipping to a minimum. Packaging materials are always
selected with regard to their possible recycling ability.
EN - 10
welding torch system, coolant recirculator, etc.
Cause
• Spring broken
• Test block soiled
• Clamping body soiled
Troubleshooting
Alignment jig
Solution
• Change the spring
• Clean the test block
• Basic cleaning