Spanset NoCut sleeve Borrador De Las Instrucciones página 13

lations (e.g. BGR 500, chapter 2.8) and retain the NoCut
Manual.
3 Operating NoCut
3.1 Attaching NoCut
3.3 "Selecting the correct size" and 3.4 "Aligning the load" should also
be adhered to here. If NoCut has already been affixed to the lifting
accessory in the factory, then there is no need to attach it.
To affix the NoCut
10
Insert the lifting accessory into one of the sleeve openings.
I.
II. Pull the protective sleeve over the lifting accessory until the middle
of NoCut protects the lifting accessory from sharp-edged loads to be
applied later.
It may be a tight fit in the case of long protective sleeves! If
this is the case, put a light band or rope through the protective
sleeve and affix it to the end of the lifting accessory, so that you can
then use it to pull the protective sleeve over the lifting accessory.
The protective sleeve is now in place. You are now able to attach
11
the sharp-edged load.
To affix the NoCut
12
When using round slings, it must be decided in advance whether one
I.
or both round sling cables need to be protected. Please also see 3.4
Aligning the load.
II a. Guide the strap through the rectangular buckle, pull tight, and
affix with the Velcro
II b. Bend the three-piece buckle (1) and insert into the fixed rectangu-
lar buckle (2); pull the strap tight. Done!
The protective pad is now affixed. You are now able to attach the
13
sharp-edged load.
The 45 mm and 75 mm versions of the NoCut
Velcro strap to aid fixing to the lifting accessory due to their
®
®
to the lifting equipment
®
®
sleeve
®
pad
tape. Done!
®
Operation
®
pad feature a
®
Page
EN
11