System Programming Connection - Lutron Energi Savr Node QS Manual De Instrucciones

Energi Savr Node
Wiring: System Programming Connection
1
QS Link
2
ESN
Programming
Interface
• Wireless router only required for programming with an Apple iPod touch or iPhone.
• Wireless router may be removed for normal operation.
• Ethernet connection may be made via an an ESN Programming Interface or an ESN QS unit with integral Ethernet jack.
• Lutron recommends that an ESN Programming Interface (or ESN QS unit with Ethernet jack) be wired to an Ethernet jack in the space
for ease of access and proximity to power for the wireless router.
• Works with any standard wireless router that supports multicast packets.
• Apple iPod touch or iPhone can program all ESN QS units connected to an ESN Programming Interface via the QS Link (except when
part of a Quantum system).
®
• ESN app is required and is available from the Apple AppStore online marketplace.
Apple, iPhone, and iPod touch are trademarks of Apple Inc.,
registered in the U.S. and other countries.
AppStore is a service mark of Apple Inc.
Energi Savr Node QS for 0-10 V / Switching Installation Guide
TM
QS for 0-10 V / Switching
TM
ESN QS unit
2
Wireless
Router
Dedicated
(by others)
Ethernet
Connection for
ESN
QS units*
* Note: ESN QS units are not designed to exist on an open network. Connection to an open network
could result in reduced performance and Ethernet connectivity issues.
|
Installation Guide
QSM
1
Apple
iPod touch
or iPhone
mobile digital
device
Wire types:
1 Less than 153 m: Lutron cable
®
GRX-CBL-346S
153 m to 610 m: Lutron cable GRX-CBL-46L
®
2 Standard CAT5/CAT5E cable: Total length not
to exceed 100 m
Lutron
|
®
9