Noise Information; Vibration Information - Worx WT626 Manual Del Usuario

Machine weight

NOISE INFORMATION

A weighted sound pressure
A weighted sound power
K & K
pA wA
Wear ear protection

VIBRATION INFORMATION

Vibration total values (triax vector sum)
determined according to EN 62841:
Typical weighted
vibration
The declared vibration total value and the
declared noise emission value have been
measured in accordance with a standard test
8
method and may be used for comparing one
tool with another.
The declared vibration total value and the
declared noise emission value may also be
used in a preliminary assessment of exposure.
.
WARNING: The vibration and noise
emissions during actual use of the power
tool can differ from the declared value
depending on the ways in which the tool is
used especially what kind of workpiece is
processed dependant on the following
examples and other variations on how the tool
is used:
How the tool is used and the materials being
cut or drilled.
The tool being in good condition and well
maintained.
The use of the correct accessory for the tool
and ensuring it is sharp and in good condition.
The tightness of the grip on the handles and
if any anti vibration and noise accessories are
used.
And the tool is being used as intended by its
design and these instructions.
Finishing Sander
2.0 kg
L : 83 dB(A)
pA
L : 94 dB(A)
wA
3.0 dB(A)
Vibration emission value
a = 6.341 m/s
2
h
Uncertainty K = 1.5 m/s²
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed.
WARNING: To be accurate, an
estimation of exposure level in the actual
conditions of use should also take account of
all parts of the operating cycle such as the
times when the tool is switched off and when
it is running idle but not actually doing the job.
This may significantly reduce the exposure
level over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in
anti vibration and noise accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.
ACCESSORIES
Paper hole punch
dust box
32mm dust extraction adaptor
35mm dust extraction adaptor
60 grit clamp sanding paper
80 grit clamp sanding paper
120 grit clamp sanding paper
If using sanding paper without dust holes,
you must use the paper punch to make
holes.
Use 1/3 sheet sanding paper of the
following size:
Sanding Paper size:
93*230mm for no hook & loop (Clamp only)
93*182mm for hook & loop
We recommend that you purchase your
accessories listed in the above list from the
same store that sold you the tool. Refer to the
accessory packaging for further details. Store
personnel can assist you and offer advice.
1
1
1
1
3
3
3
EN