WeatherTech Easy-on Instrucciones De Instalación página 3

Installation Steps
Raise hood again. Align fastener previously installed
in hoodshield with hole in passenger side of the
hood. Insert fastener in hole and tighten. Repeat for
9
CAREFULLY raise hood and check grill alignment.
Reinstall previously removed nuts
11
13
Care and Cleaning
Care and Cleaning
• Wash only with mild soap & dry with a clean cloth.
© 2011 by MacNeil IP LLC
NOTE: Actual application may vary slightly from illustrations.
opposite side.
.
Lower hood and install (4) bumpons on pre-cleaned areas of hood surface
Lower hood again, and replace grill. Ensure that all
holes are aligned correctly and grill is flush against
10
lock rod
12
Page 3 of 3
the hood shield flange.
.
Reconnect hood lock rod
.
lock
mechanism