Before First Use - Concept VP4210 Manual Del Usuario

EN
USER'S MANUAL

BEFORE FIRST USE

1. Secure the tube
2. Insert the appliance
with the handle to
body into the suction
the appliance body nozzle.
CHARGING
1. Put the hand vacuum cleaner in the appliance body and start charging.
2.
The hand vacuum cleaner can also be charged separately.
VP 42 00 56
3. Put the hand vacuum
cleaner in the appliance
body.
VP4210
E N E N
If the blue diode starts flashing during operation, it means that the battery is empty and the vacuum cleaner
needs to be charged.
1. Press the button on the handle and turn off the appliance.
2. Disconnect the appliance plug from the wall socket.
3. Connect the charger connector to the accumulator in the vacuum cleaner body.
4. The blue LED will flash, indicating that the appliance is charging normally.
5. As soon as the blue LED stops flashing and starts to shine continuously, the battery is fully charged.
6. Disconnect the charger from the battery and store it in a safe place.
7. The hand vacuum cleaner can be charged individually and when attached to the body of the main
vacuum cleaner.
Attention:
Do not pour water into the charging slot on the body of the appliance to avoid damaging the appliance.
Do not store or recharge the appliance in environment with temperatures below 0 °C or higher than 40 °C.
These temperatures may damage the appliance.
During the charging process, the temperature of the appliance may increase, this is normal.
USE
(for hand vacuum cleaner)
1
Press this button to release
the hand vacuum cleaner
and remove it from the
main body.
4 5 VP4210 4 6
Press the button for the first time to switch on
2
the vacuum cleaner with lower suction power.
Press the button a second time to turn on higher
suction power. Press the button a third time to
turn off the vacuum cleaner.
3
Put the slot nozzle into the hand vacuum cleaner.
4
Now you can start vacuuming.
EN
VP 42 00 57