Setup / Installation; Assembly / Disassembly - Sera MU-100 E 1500.2 Manual De Instrucciones

Electric agitator
MU-...E(G)1500...
Operating instructions

6. Setup / Installation

The mixing unit is only approved for the installation in dry areas in a non-aggressive atmosphere at temperatures
■
between +2°C and +40°C and an air humidity of up to approx. 90%.
No direct exposure to sunlight
■
For the dimensions of the fixing holes of the protective flange, see chapter "Dimensions".
■
Check the fixing screws for tightness and, if applicable, retighten (tightening torques for fixing screws see chapter
■

"Assembly / Disassembly").

Install the mixing unit at a user-friendly height.
■
Maximum installation height is 2000m (reduction in performance above 1000m above sea level).
■
7. Assembly / Disassembly
Prior to the work, turn off the power and protect the system from being turned on again!
■
In case of contact with live components there is a danger to life.
Switched on electrical components may cause uncontrolled movements
and lead to serious injuries!
DANGER!
Prior to the work, ensure that there is sufficient space to perform the installation.
■
Be careful when handling sharp-edged components.
■
Make sure the work station is tidy and clean! Loose parts or parts and tools lying around may cause accidents.
■
Secure components so that they can not fall down or topple over.
■
An improper installation and initial start-up may lead to serious damage to persons or
property!
CAUTION!
The mixing unit may only be assembled/disassembled if the tank is empty.
WARNING!
TA 452 Rev. 4 en 03/2015
Subject to technical modifications!
49
www.sera-web.com