• Do not place the appliance on a carpet while in use.
• Please do not use multiple plugs or extension cords.
Warning: In order to avoid overheating, do
not cover the heater!
Components
Side view:
Front
Air outlet
Fireplace
simulation
Base
Installation
•
Please remove all packaging materials.
•
Place the unit on a table so that the bottom of the unit is freely accessible.
•
Please attach the base to the bottom of the unit by pressing the base against the bottom of the unit until
it clicks into place. Please set up the completely assembled appliance with the base.
Operation
•
Operating voltage: 220-240V~, 50/60Hz, 2000W
•
Control panel:
Value increase/
decrease for timer
On/Off
Heat setting
Eco mode
•
Please ensure that the unit is correctly positioned according to the safety instructions, then connect it to
the power supply.
•
Please tilt the switch on the back of the unit to the "I" position. An acoustic signal sounds and the unit is
Back
Remote control compartment
and handle
Air inlet
On/Off switch
Cord with
power plug
Top view:
Base
Control panel
LED display with
value and indicating
lights
Value increase/
decrease for temperature
Fireplace simulation
Oscillation