Suntec Wellness Klimatronic HEAT PTC 2000 FLAME Manual Del Usuario página 16

Please remove the unit from the power supply and allow it to cool down before proceeding
with operation.
•
Remote control:
On/Off
Value increase/
decrease of timer
Heating level
Please open the battery compartment on the back of the remote control by pressing the latch
o
to the right while pulling out the compartment. Please insert 1 x CR2032 battery (not included)
with the "+" side facing up and slide the battery compartment back into the remote control:
The remote control can be used to make the same settings as on the control panel.
o
•
Please press the on/off button to switch off the fan heater. The display shows a 10-second countdown
while the built-in DC fan is running. At the end of the countdown, the unit returns to standby mode. If
you switch the unit on again by pressing the on/off button, the previously stored settings, with the
exception of the timer setting, are active. In standby mode, tilt the switch on the back of the unit to the
"O" position to turn the unit off completely. Please remove the appliance from the power supply.
Cleaning
•
Always disconnect the appliance from the power outlet and let it cool before cleaning. Never immerse
the appliance in water to prevent electric shocks.
•
Wipe over the exterior of the appliance with a soft wet cloth and then wipe dry with a dry cloth.
If necessary, you can use the cloth with lukewarm water and neutral cleaning agent. Please allow the
outer surfaces to air-dry.
•
Please do not use any aggressive or chemical cleaning agents or abrasive cleaning agents such as
petrol, thinners or steel wool.
•
Please store the cleaned unit in a cool, dry and well-ventilated place.
Fireplace simulation
Value increase/
decrease of temperature
Oscillation