Daily Maintenance - EdilKamin BIJOUX Instalación Uso Y Mantenimiento

MAINTENANCE
Before performing any maintenance, disconnect the appliance from the mains.
Regular maintenance is required for the boiler-stove to function correctly.
The boiler-stove will trigger the message: 'smoke °C/high' or 'Mainten.' to appear on the panel when further cleaning is
necessary. This is preceded by 'Clean exchang.' appearing on the display.
FAILURE TO PERFORM REGULAR MAINTENANCE, at least on a SEASONAL basis, could lead to poor functionality.
Any problems resulting from lack of maintenance will immediately void the warranty.
NOTE: The DEALER, upon commissioning, sets the kg value of consumed pellets; after which, the message "SERVICE
UTE" will appear on the display. The boiler-stove continues operation, but the end client is invited to perform careful
maintenance, described above and explained by the DEALER during commissioning, to the extent of his abilities. To elimi-
nate the message from the display, press the ventilation button for at least 5 seconds after having completed maintenance.
N.B.
- Any unauthorised modi cation is forbidden
- Use spare parts recommended by the manufacturer

DAILY MAINTENANCE

Operations must be performed when the stove is off, cold and unplugged from the power supply.
Cleaning should be carried out with the aid of a vacuum cleaner (see optional page. 57), the whole procedure takes up a few minutes.
• THE CLEANING RODS (*) MUST BE AGITATED ONCE A DAY WITH THE GLOVE IN EQUIPMENT ALSO FRE-
QUEN WHILE THE BOILER-STOVE IS IN FUNCTION) IN ORDER TO ALLOW FOR FUEL SAVINGS:
Shake the cleaning rod by the handle supplied, located towards the top on the front, below the tank cover ( g.A).
• Open the door, remove the combustion chamber (1 - g. B) and empty the residue out into the ash pan.
• Scrap the combustion chamber with the spatula provided, removing any obstructions in the openings.
• • DO NOT EMPTY THE RESIDUE OUT INTO THE PELLET HOPPER.
• Take out and empty the ash (2 - g B) pan into a reproof container (the ash may still contain hot parts and/or embers).
• Remove the combustion chamber or use the spatula to scrape it and clean out any blocked holes on all sides
• Vacuum the combustion chamber holder, clean the edges where the combustion chamber is lodged into its seat.
• Clean the glass, if necessary (when cold).
NEVER SUCTION HOT ASH, as this could damage the suction device and possibly cause a re.
ATTENTION: MAKE SURE THE ASH PAN IS CORRECTLY POSITIONED IN ITS HOUSING
1
*
2
g. A g. B
- 52
-