Axxess AX-ADFD100 Instrucciones De Instalación página 7

Installing the AX-ADFD100
With the key in the off position:
• Connect the LD-AX-ADFD02 harness into the interface, and then
into the vehicle.
• With all connections completed, reconnect the negative battery terminal.
Note: If using the ASWC-1, connect it after you initialize and test the
AX-ADFD100, with the key in the off position.
Initializing the AX-ADFD100
Attention: If the AX-ADFD100 loses power for any reason, the following step will
need to be performed again.
• Initialize the interface by turning the ignition on for 30 seconds, then turn the
ignition back off, then back on again.
Adjusting the AX-ADFD100
Audio Level Adjustment (if equipped with a SONY/THX amplifier)
• With the vehicle and radio turned on, turn the volume up 3/4 of the way.
• Locate the end of the Interface with the 16-pin harness with stripped leads.
• With a small screwdriver, adjust the potentiometer clockwise to raise the audio
level; counterclockwise to lower the audio level.
• Once at a desired level, the audio level adjustment is complete.
AX-ADFD100
SYNC and AUX-IN:
• If your vehicle is equipped with SYNC or AUX-IN, the AX-ADFD100
can retain these features.
• Change the source of the radio to AUX-IN; SYNC audio will play
if SYNC has been activated.
• Either the vehicles display, or the optional AX-LCD (sold separately)
will display the SYNC information.
• Listed below are the functions of the AX-LCD:
Arrow up—Channel up (only in SAT or USB mode)
Arrow down—Channel down (only in SAT or USB mode)
Enter—Selects current item on the screen
Return/ESC—Exits to the previous screen
• To access AUX-IN, press and hold the MEDIA button on the steering wheel for
2 seconds. This will switch to the next available source in your vehicle. Each
time the MEDIA button is pressed for 2 seconds the source will change. The
sequence of sources are SYNC/RSE/SAT/AUX-IN. To temporarily disable SYNC
or AUX-IN, press and hold the MEDIA button for 3 seconds. To turn it back on,
press the MEDIA button for 2 seconds. There will be a visual confirmation of
what source you are on from the factory screen, or the AX-LCD. This screen
will also provide SYNC information.
Note: Disregard RSE and SAT in the sequence of sources,
they are not applicable in this application.
7
Extra features