Stryker 4103-126-000 Manual De Instrucciones página 5

EN
Features
A
B
A Pre-adjust Knob – Used to prepare the
collet to accept the correct pin diameter
size.
B Knob Pin Holes (2) – Used to receive the
knob pin.
C Knob Pin – Used to insert into either the
small or large pre-adjust knob pin hole.
D Nose – Allows the insertion of the pin into
the collet.
E Clamping Lever – Used to clamp or grasp
the pin before insertion or removal.
4
Print Date: Sep 21, 2016 02:12:36 PM
0000000958, Rev. F Effective Date: Sep 21, 2016 11:14:29 AM
D
E
C
Instructions
WARNINGS:
• ALWAYS place the handpiece in the SAFE mode
while the handpiece is idle, before installing or
removing any accessory or attachment, or when
passing the handpiece to another person.
• DO NOT attempt to insert or remove any cutting
accessory or attachment while the handpiece is
operating.
To Install the Attachment
See the instructions for use supplied with the
handpiece.
To Insert the Pin
1. Set the pre-adjust knob for a small (S) or large (L)
pin diameter range by pulling and rotating the knob
until S aligns with S or L aligns with L, respectively.
NOTE: Make sure the knob retracts and locks in place
when the symbols align.
4103-126-702 Rev-F
www.stryker.com