Servicing; Cleaning The Device - Cub Cadet L20 Manual Del Usuario

EN
–
–
During an engine start, the battery voltage is
displayed briefly and then the total operating hours.
If battery voltage too low:
Charge the battery as quickly as possible.
Î
It may be necessary to have the charging system
Î
checked by a service centre for possible damage.
If battery voltage too high:
Switch the device off and have the charging
Î
system checked by a workshop.
– –
Perform air filter maintenance immediately (see
Î
engine operating manual).
This indicator appears every 25 operating hours for
a period of 7 minutes.
Other indicators in the display
Brake / parking brake not actuated during
engine start attempt.
a) Mower not switched off during engine
start attempt.
b) OCR function was not activated prior to
mowing in reverse.
Operator not sitting on the driver's seat
during engine start attempt.
22
Battery voltage
Low (< 11 Volt)
High (> 16 Volt)
Air filter maintenance

Servicing

Risk of injuries or material damage
¾ Only perform maintenance and cleaning
work on the device with the engine at a
standstill.
¾ Remove the ignition key and the spark-
plug connectors.
¾ Wait until all moving parts have come
to a complete stop and the engine has
cooled down.
¾ Never reach into the rotating cutter
blades.
¾ Only have repair and maintenance
work and the replacement of safety
components performed by a qualified
specialist or a specialist service centre.
¾ Only have the cutter blades replaced
or re-sharpened by a specialist service
centre.
¾ Clean the device and all add-on and
accessory parts after every instance of
use.

Cleaning the device

Attention!
¾ Do not use high-pressure cleaners for cleaning
the device.
Park the mower on firm and level ground.
Î
Switch the parking brake on.
Î
Clean the device with a scrubbing brush, hand
Î
brush or a cloth.
Cleaning the cutter deck
Sharp, moving cutting tools
ÂRisk of injury
¾ Wear protective gloves.
¾ Clean the cutting tools carefully.
¾ Note that the movement of one cutting
tool may lead to the rotation of other
cutting tools.
WARNING!
DANGER!
Servicing