Ro Membrane Installation - Zepter AqueenaPro WT-100 Manual De Instrucciones

EN
Note!
The fi rst two tanks can contain black residues.
These are carbon particles washing away from the carbon fi lter and
will not affect future system performance nor the quality of purifi ed water.
11. Measure TDS level and record it on your Product Warranty Card.

RO Membrane Installation

Note!
• The AqueenaPro water purifi er is delivered with the RO membrane uninstalled
and packed separately with protective fi lm.
• In order to prevent microbial contamination of membrane components during storage
and transportation, the RO membrane package contains a small amount of protective solution.
1. Remove the AqueenaPro top cover.
2. Unscrew the cap's nut from the membrane housing and remove inlet water pipe.
3. Disassemble membrane cap with the enclosed wrench.
4. Remove RO membrane from its protective fi lm.
5. Insert RO membrane into membrane housing. The membrane end with O-ring must be placed
on the bottom of the housing. (see picture below)
6. Close the membrane casing with the cap. Use the wrench to tighten the cap properly.
7. Connect the inlet water pipe and secure it with the cap's nut.
8. Place the RO membrane cartridge in the correct position.
9. Check all connections and make sure that there are no leaks.
10. Close the AqueenaPro top cover.
14
O-rings
cartridge
cap
membrane