The Ro Replacement Procedure; Filter Replacement Time - Zepter AqueenaPro WT-100 Manual De Instrucciones

The RO replacement procedure

1. Turn off the power supply.
2. Close the inlet water valve.
3. Remove the top cover.
4. Unplug the "old" fi lter – disconnect fi lter from quick connectors
5. Replace the fi lter – Pay attention to correct water fl ow direction!
Cartridge
6. Check all connections and make sure there are no water leaks.
7. Close the top cover.
8. Open the inlet water valve and turn on the power supply.

Filter Replacement Time

The AqueenaPro water purifying system is equipped with a special system to monitor fi lter life time.
The system automatically monitors fi lter conditions and the current status is shown on the Filter
Status Display.
Green light – the fi lter works at its optimum level.
Orange light - the fi lter will soon need replacing. Please contact Zepter Service for maintenance
support.
A red light along with an audible alarm (4 buzzes) means that the fi lter must be changed imme-
diately. Further use of the fi lter is not recommended.
Attention!
Max. recommended fi lter replacement cycle represents time equivalent of AqueenaPro
engaged in the process of fi ltration.
Theoretical model used in the calculation of max. recommended fi lter replacement cycle is
based on 10L per day of purifi ed water consumption. For demand exceeding the model assumptions,
replacement cycle may vary.
The fi lter replacement cycle is not the fi lter quality warranty period, but the expected cycle (lifetime)
when the fi lter shows its original performance. The lifetime of the fi lter is affected by the daily water
consumption and inlet water condition, therefore, the fi lter replacement cycle may be shorter for the
areas where the water contains high level of suspended solids (particles, sediments, etc.)
O-ring RO-Membrane
Cap
EN
19