Publicidad
locate the access hole on each
side of the vehicle leading to the
tail light wiring harness (fig. 3A).
All Vehicles:
4. Beginning with the right
(passenger) side, route the T-
Connector harness ends with the
green wires out from inside or under the vehicle,
through the body opening to the right tail light housing
assembly.
5. Disconnect the CENTER Black vehicle harness connector
from the (passenger) side taillight, taking care not to damage
the locking tabs. Check the connector for dirt and debris and
clean if necessary.
6. Using the T-Connector harness ends containing the green
wires, firmly press the connector ends into the center tail light
housing socket and the connector removed in step 5 until the
locking tabs engage. Take care not to damage the locking tabs.
7. Route the T-connector ends with the yellow wire to the
left (drivers) side of the vehicle and route the connectors out
through the body to the left side tail light housing.
8. Repeat steps 5 & 6 for the left tail light housing using the
T-Connector ends with the yellow wires.
9. Confirm correct operation with a test light or by using a
trailer.
Full Size Vans & SUV's
10. Secure the yellow wire under the threshold trim removed
in step 3. Return all trim panels to their original positions and
A
Fig. 3
Publicidad
