Warranty; Ec Declaration Of Conformity - Brill MS 427 B Manual De Instrucciones

Warranty

PROBLEM
Motor runs spasmodically
Excessive smoke
In the case of faults that are not listed in this table, or faults that you cannot rectify without
assistance, please contact our customer service department.
WARRANTY
If any material or manufacturing defects are found during the statutory customer protection period, we
will either repair or replace the equipment, whichever we consider the more appropriate. This statutory
period may vary according to the legislation in force in the country where the equipment was purchased.
Our warranty is valid only if:
The equipment has been used properly
The operating instructions have been followed
Genuine replacement parts have been used
The following are not covered by warranty:
Paint damage due to normal wear
Wear parts identified by a border [xxx xxx (x)] on the spare parts list
Combustion motors (these are covered by a separate warranty from the manufacturer concerned)
The warranty period begins on the purchase by the first end user. Decisive is the date on the receipt.
To make a claim under warranty, please take this statement of warranty and proof of purchase to the
nearest authorised customer service centre. This warranty does not affect the usual statutory rights of
the customer relative to the seller.

EC DECLARATION OF CONFORMITY

We hereby declare that this product in the form in which it is marketed by us complies with require-
ments of the harmonized EC directives, EC safety standards and the product-specific standards.
Product
Brush cutter
Type
MS 427 B
Serial number
G 230 2305
Kötz, 6 June, 2012
Antonio De Filippo
Managing Director
440 271_a
POSSIBLE CAUSE
Dirty, incorrectly adjusted or
wrong spark plug
Incorrect fuel mixture
Manufacturer
AL-KO Geräte GmbH
Ichenhauser Str. 14
D-89359 Kötz
EC Directives
2006/42/EC
2004/108/EG
2000/14/EG (13)
2002/88/EG
Sound power level
measured: 109 dB(A)
guaranteed: 113 dB(A)
CORRECTION
Clean, adjust or exchange the
spark plug
Use the correct fuel mixture
The warranty is no longer valid if:
The equipment has been tampered with
Technical modifications have been made
The equipment was not used for its intended
purpose
Authorised representative
Anton Eberle
Ichenhauser Str. 14
D-89359 Kötz
Harmonised standards
ISO 11806:2009-01
ISO 14982:1998-09
Conformity assessment
2000 /14/EC Appendix V
21