Saf-Fro DIGISTEEL III 420 Instrucciones De Funcionamiento Y Mantenimiento página 28

Spot cycle
Pressing the trigger activates wire feed and pre-gas and turns on the welding current. Releasing the trigger causes the welding to stop.
Adjustment of the Hot Start, down-slope and sequencer settings is disabled. At the end of the spot time-delay, welding stops..
Sequencer Cycle
The sequencer is enabled by the parameter
To get there :
The ' "appears in the submenu "
tSE
tSE : Duration of 2 levels if  OFF
ISE : current du 2nd step in % 1
Only synergistic mode, cycle 2T or 4T
« tSE  0FF » " in the sub menu of SETUP specific cycle
"
" ." Set this parameter between 0 and 9.9 s
CYCLE
level
er