Mopar 82212323 Manual De Instrucciones página 3

NOTE: The grommet is a double sided grommet with
rubber inside the vehicle side and outside the vehicle.
Be sure to pierce all the way through both sides. Be
careful not to compromise the engine wiring harness
while piercing the grommet.
15. From under the hood on the RH side of the cowl, care­
fully pierce the second rib (2) of the engine harness
pass through grommet (1) and route the fog lamp to
BCM harness (3) (loose wire end) into the passenger
compartment.
NOTE: Just prior to pulling the fog lamp to BCM har­
ness (1) through the grommet, apply RTV sealant to
the wiring harness ¼ inch before the conduit (in the
engine compartment) to seal it.
16. From inside the passenger compartment, locate the
fog lamp to BCM harness (1) and pull thorough to seat
the harness conduit against the grommet in the engine
compartment.
17. Route the fog lamp to BCM harness (1) toward the RH
kick panel and secure with tie straps (3) as necessary.
NOTE: The Body Control Module (BCM) (5) is located
on the RH kick panel.
18. Disconnect BCM connectors A (1) and D (3) by press­
ing on the release lever lock tab (2), then swivel the
release lever (4) and pull the connectors (1, 3) from
the BCM (5).
Nov 24, 2010
3
K6861133