4
19. For both connectors A and D, using trim stick C4755
or equivalent, carefully insert between connector
cover latch (2) and the lock tab (3) to release, and
slide the connector housing (1) off the connector.
NOTE: The cavities in the BCM specified for the RH
and LH fog lamp wires may be populated. If so, the
existing wires must be removed to install the fog lamp
kit wires.
20. Route the wires to the BCM connectors and insert the
LH fog lamp power circuit WT/YE into connector A (1),
cavity 1 (2). Install the connector cover and connect
BCM connector A (1).
21. Insert the RH fog lamp power circuit WT/DB into con
nector D (2), cavity 13 (1). Install the connector cover
and connect BCM connector D (2).
Nov 24, 2010
K6861133