Mopar 82212323 Manual De Instrucciones página 6

6
29. For Chrysler only, install the fog lamps from behind
the bumper fascia by locating the five tabs to the slots
(2) in the fog lamp housing (1) and firmly pressing into
place. Make sure all tabs are fully seated.
NOTE: If equipped, remove the screw retainer clips
from the fascia before positioning the fog lamps.
30. For Dodge only, position the fog lamps from behind
the bumper fascia and install the two screws through
the fascia (from outside the fascia) directly across from
each other.
31. Route the RH side of the fog lamp harness (2) above
the Electro­Hydraulic Power Steering (EHPS) pump
(1) to the RH fog lamp and connect to the fog lamp.
32. Pass the fog lamp harness to BCM harness connec­
tor end (2) up inside the body for routing in the en­
gine compartment (forward of Antilock Brake System
(ABS) Module). Attach the harness to the body at this
point using a tie strap (3), but leave tie strap (3) loose
enough to pull wiring harness (2) slack out from above.
Nov 24, 2010 K6861133