FOTILE RLS30506 Manual De Usuario página 19

Problem
Sparking but no flame
ignition.
Igniters spark continuously
after flame ignition.
Burner flame goes out at
low setting.
The flames have
suddenly gone out.
There is a power failure –
can I still use the cook
top burners?
2) Oven
Problem
The oven will not turn on.
Probable Cause
Gas shut-off valve is in the
'OFF' position.
Power supply polarity is
reversed. Igniters are wet or
dirty.
Low gas supply pressure.Air
intake holes around knobs
are obstructed.
A draft or a spill has
extinguished the flame.
Power outage in your area.
Probable Cause
The range is not completely
plugged into the electrical
outlet.
A fuse in your home may be
blown or the circuit breaker
tripped.
The oven controls have been
set improperly.
The oven is too hot.
Incomplete service wiring.
18
Solution
Turn shut-off valve to the 'ON'
position.
Have polarity corrected. Dry or clean
igniters.
Contact gas company.Remove
obstruction.
No action required. The burner will
detect this and automatically relight.
However,if there has been a large
spill, we recommend turning the
burners off and cleaning the burners
and sump area. See'Care and
cleaning' for instructions.
The cook top burners can still be used.
To light them:
Holding a lighted match to the flame
spreader,push in on the control knob
and turn counterclockwise to LITE.
When the flame is burning all the way
around the burner, you may adjust the
heat.
Important!
If the flame is blown out during a
power failure, turn the knob
immediately to OFF,as the burner will
not automatically relight and gas may
escape.
Solution
Make sure the electrical plug is
inserted into a live,properly
grounded outlet.
Replace the fuse or reset the
circuit breaker.
See the chapter on operating
the oven starting on page 11.
Allow the oven to cool.
Call for service.