Auto Recording - Ega Master EGATronik 51264 Manual De Instrucciones

Hold the button 9 (menu) to select :
A. USB
Press the button 8 from the position USB0 to USB1. The system will take the value selected
as the default value.
B. AUTO off mode
Press the 8 button to move from the position AP00 (power) to the AP01 (auto off) and
maintained after the shutdown. The default value is retained and does not require any
restoration after power.
C. AUTO recording
"REC" is displayed on the screen along with the self-recording time, between 0.5 to 255
seconds. Press button 2 to extend the auto recording time. Press the 8 button to reduce this
time. Press and hold the 9 button to keep the default value after power down. The default value
is retained and does not require any restoration after power.
D. Restore factory settings
The LCD will display the letters DEF.
You can reset the default values provided by the manufacturer. Press the button 2 in this
case to restore the default values USB0, AP01 and 60S.
Otherwise, pressing again the button 9, it will be possible to override the factory defaults.
• Power ON: Press the "Power" button for a time to switch on the device.
• Wind speed and wind flow, press button "VEL / FLOW". VEL (speed of the wind) to
FLOW (wind flow).
• Data Hold: Press "Hold" button to capture data, and then press again to cancel the data
capture feature.
• Measuring the wind speed: before starting the measurement of wind speed, press the
"UNIT" m / s → ft / min → KNOTS → Km / hr → MPH to select the unit of measure.
• Wind flow measurement: before starting the wind flow measurement, press the "UNIT"
CMM → CFM for a unit of measure.
• Wind input area:
1. Set the wind input area before measuring the wind flow.
2. Set the area as 1m
measurement-wind flow. Then click "Sample" button to give input to the area. The LCD display
KEYIN with a blank space at the top.
3. Insert the data with four digits; this data will be displayed.
Example:
Enter 1, 0, 0, 0 Mean 1000 LCD display "1000"
Enter 1 ,., 0, 0, 0 Mean 1.000 LCD display " 1.000 "
Enter 1 , ., ENTET Mean 1.0 LCD display " 1.000 "
Enter 1, ENTET Mean 1 LCD display "1.000"
Enter 0, 0, 0, 1 Mean 0001 LCD display "1.000"
16
ANEMOSCOPE SETTINGS
USE OF THE ANEMOSCOPE
by default after the start of measuring wind flow. Select the unit of
2