Publicidad
USING AUTOMATIC NEEDLE THREADER
* Be sure to raise the presser foot lifter and raise the needle to
its highest position before threading.
NOTE: For smooth threading, it is recommended that
the machine be set for straight stitch (in center needle
position) when using the automatic needle threader.
1. Hook thread to the thread guide on the needle bar and pull
it toward you leaving about 4" (10 cm) clear.
2. Hook thread to the twin thread guide (A and B).
3. Pull thread gently into the thread cutter/holder to cut and
hold it in place.
NOTE: Don't pull thread with strong force or thread
may be pulled off from needle hole after threading.
4. Pull down the threading lever until the twin thread guide
rotates and stops.
NOTE: Make sure that the guide doesn't touch
fabric, etc.
5. Release the threading lever and needle will be threaded
automatically. If it should not return to the original position,
raise it gently by hand.
6. Pull thread loop away from you.
1
Felt disc
Rondelle de feutre
Thread guide
Guía hilo
Threading hook
Gancho del ensartador
4
Threading lever
Palanca de ensartado
20
Note:
2. Don't lower the threading lever while the machine is
3. Put a drop of sewing machine oil onto the felt disc,
4. If the threading hook is deviated from needle hole,
2
Twin thread guide
Guía doble hilo
A
B
5
in operation or the threading hook may be broken.
if the machine is used after a long interval.
adjust the position of the hook.
3
Thread cutter/holder
Cortador de hilo
6
Publicidad
Capítulos
