Charging Procedure - Motorola Solutions PMLN7093 Guia Del Usuario

OPERATING INSTRUCTIONS
The charger pockets will accommodate either a radio with a battery attached or battery
alone. Prior to charging a battery with radio, turn the radio off. Batteries charge best at
room temperature.
Note: This Multi Unit Charger is able to charge radio with battery, "Radio with Battery
plus Hand Strap" and stand alone battery.
Charger Power

CHARGING PROCEDURE

1. Plug the charger end of the power cord into the power receptacle located at the
bottom of the charger.
2. Plug the wall receptacle end of the power cord into appropriate AC outlet. A
successful power-up sequence in indicated by a SINGLE FLASH GREEN on the
charger indicator.
3. To charge a radio with battery (with the radio turned off):
a. Slide the radio into the charger pocket and align it to the groove on each side of
the radio with the corresponding raised rail on each side of the charger pocket.
b. Ensure complete contact between the charger and radio contacts.
c. See radio indication display for charging status.
d.
4. To charge a stand-alone battery, insert the battery into the pocket of the charger by
(See Figure 2):
a. Aligning the raised tab on each side of the battery with the corresponding
groove on each side of the charger pocket.
b. Pressing the battery toward the rear of the pocket.
c. Sliding the battery into the charger pocket, ensuring complete contact between
the charger and battery contacts.
d. When the battery is properly inserted into the pocket, the charger will indicate
the Battery Level status as shown in Table 4. The charger indicator will illuminate
in STEADY RED to indicate that the battery is charging rapidly.
e. When the battery is fully charged, charger indicator changes to STEADY
GREEN.
Receptacle
Figure 1: Multi Unit Charger
Radio Charging
Contact
Battery Charging
3
Contact
Charging
Indicator
(LED)