Mounting Instructions - Motorola Solutions PMLN7093 Guia Del Usuario

MOUNTING INSTRUCTIONS

Warning:
For safety and stability, it is recommended that you use the appropriate wall mounting
hardware for installation. For safe mounting, it is essential to use wall anchors appropriate to
the wall type (i.e. plaster, drywall, concrete, etc.). Mount to wood studs whenever possible.
The Multi-Unit Charger comes with wall mount features. Please follow the following
guidelines to mount the charger:
1. Ensure that the Multi-Unit Charger is mounted on a secure wall and must be free
from obstructions such as wall braces, wires, or other impediments.
2. Measure and mark the drill holes by using the dimensions as shown in Figure 3.
3. Drill and fasten the 4 screws and wall anchors to the secured wall (screws and wall
anchor not included in kit). Be sure to use appropriate anchors and screws for the
type of wall the unit is being mounted to.
Note:
It is recommended to use Pan Head M3 screws. The screw length depends on the wall
thickness and should not be shorter than the thickness of the wall, up to a maximum length
of 2 inches.
4. Mount the Multi-Unit Charger onto the wall by aligning it to the screws on the wall.
Ensure that it does not wobble.
SERVICE
The Multi-Unit Charger is not repairable. Order a Replacement Charging Kit if necessary.
FOR MORE INFORMATION, VISIT
https://learning.motorolasolutions.com
MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M logo are trademarks or
registered trademarks of Motorola Trademark Holdings, LLC and are used under license. All other
trademarks are the property of their respective owners.
© 2014 and 2019 Motorola Solutions, Inc. All rights reserved.
Multi-unit charger
mount screw holes
See detail
Ø3.80 mm
Ø 9.00 mm
Screw/wall
anchor hole size
Figure 3: Wall Mounting Features
318.00 mm
6
19.05 mm