Motorola PMLN7018 Guia Del Usuario página 14

01_EN.fm Page 12 Monday, March 28, 2016 10:08 AM
Follow steps in Table 2 after inserting the TETRA
Handportable Terminal into the cradle and turning the ignition
switch to ON.
Table 2: Troubleshooting Procedures
No. Malfunction
1 Display
message
"Charger/
Holder
Connected"
does not exist.
2 Charging
Indication does
not exist.
MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M logo are
trademarks or registered trademarks of Motorola Trademark Holdings, LLC and are
used under license. All other trademarks are the property of their respective owners.
© 2012–2016 Motorola Solutions, Inc.
All rights reserved.
Corrective Action
1. Remove the TETRA Handportable
Terminal from the cradle and install it
again.
2. Check the cradle accessory connector.
Ensure the cradle is connected
properly.
1. Verify that the ignition switch is in the
ON position.
2. Check the power cable. Verify that the
red wire is connected to the positive (+)
terminal on the vehicle's battery, the
black wire is connected to the vehicle's
chassis and the blue wire is connected
to the ignition line.
3. Check the fuses installed on the red
and blue wires. Verify their
serviceability and replace if required.
12