DDIN / STACKED ISO DIN
HEAD UNIT PROVISION
1
Cut and remove the center bar from
the radio housing. (Fig. A)
2
Snap the Double DIN brackets to the
inside edge of the Double DIN trim
plate. (Fig. B)
3
Slide the Double DIN head unit or
stacked ISO head units into the
bracket/radio housing assembly (from
behind) and secure the Double DIN
head unit or stacked ISO head units to
the assembly using the screws supplied
with the radio. (Fig. C)
4
Snap the Double DIN trim plate into
the radio housing. (Fig. C)
5
Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from Metra
or AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
6
Reassemble dash in reverse order of
disassembly.
99-7517S KIT ASSEMBLY
A
B
B
5