Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
them into each other. Do not whip out the pole sec-
tions so they snap together. Make sure that each
pole section is fully inserted into the next section;
otherwise they may crack or break under pressure.
Gently slide the poles through the pole sleeves.
Do not pull them through.
3. Erect the tent and make sure that the entrance zip
is not under undue tension or strain which could
easily damage the zip. Use the releasing lock or
hook at the bottom of the entrance.
4. Stakes should be driven in at a 45° angle away
from the tent (X).
The VAUDE Y-stakes that come with our tents
are very durable and resistant to bending and
especially suited for hard ground and grass. For
extremely hard ground, we recommend the use
of tent pegs or spikes. VAUDE offers special stakes
for very soft ground, snow or sand. Hammer them
in vertically for soft soil or bury them horizontally to
anchor in sand or fresh powder snow (Y).
10
SETTiNG UP – "modEL-SPECiFiC":
Please follow these instructions step by step, the order
is important.
1. Clear the ground of any sharp items
(We recommend the use of an optional grounds-
heet protector).
2. Spread out the tent on the ground. Please note:
Inner and outer tent are delivered attached to
each other.
3. Lay out and assemble the poles. There are two
sets for the porches (A1), 2 short roof poles (A2)
and 2 long poles (A3).
4. For each set of porch poles (A1) put one into the
eyelet at the base of the window side of the porch
(B).
5. One after the other push the roof poles (A2) up
towards the porch poles (A1) and then connect
them (C).
6. Now push the two long poles (A3) into the tunnel
section (d). The lower arch should be at the back,
the higher one at the front; then the cover for the
porch should be clipped to the porch poles (E).
Publicidad
