Caring For Your Steam Cleaner - Shark S6005EU Instrucciones

CARING FOR YOUR STEAM CLEANER

After Use and Storage
1 Press the Steam Control Button until it starts
to blink, indicating that you are in Standby
mode. Unplug the cord from the socket and
place the Steam Cleaner into the upright
position. Let it cool.
2 To remove the Dirt Grip pad, lift the Steam
Cleaner straight up by the handle until the
Intelli-Mop Head is hanging straight down.
Press the pad release buttons on the neck of
the mop head, and both sides of the Intelli-
Mop Head will drop open, releasing the pad.
Once the pad has been released, close the
Intelli-Mop Head.
3 If the Intelli-Mop Head is not attached to the
mop, the pad can still be removed. Press down
on the release button on the Intelli-Mop Head
post to release the pad (Fig. 21).
4 Empty the water tank before storing. To empty
the tank, hold the Steam Cleaner beside a sink.
Open the water tank lid, then lean the unit
over the sink. Let the water drain out, then
close the lid.
5 To store the Steam Cleaner, wait until after it
has cooled and the steam has been released.
15
s h a r kc l e a n . e u
Fig. 21 Fig. 22
Fig. 23
Dirt Grip Pad Care InstructionsCare
Machine-wash the Dirt Grip pads separately with
warm water using liquid detergent.
NEVER USE BLEACH, POWDERED DETERGENT,
OR FABRIC SOFTENERS as they may damage
or leave a coating on the Dirt Grip pads that
will reduce their cleaning performance and
absorbency. Dirt Grip pads should be line-dried
or tumble-dried on a low setting, as this will
extend the life of the microfiber fabric
(Fig. 23).
Loose fibres can indicate wearing of the
microfibre fabric. Do not pull the loose fibers, as
this can cause the weave to come undone. Simply
trim the loose fibers with scissors (Fig. 24).
Fig. 24
Replacement Dirt Grip pads
For best cleaning results, we recommend
replacing your Dirt Grip pads every 3 to 4 months
following normal use. As with any fabric, dirt
particles, grease, friction, and repeated washing
can cause the fibers to break down, and you may
notice an increase in the effort needed to push or
pull the mop.
You can purchase replacement Dirt Grip pads and
other accessories by visiting sharkclean.eu/parts
and accessories or calling 0800 862 0453.
Steam Nozzle Care
If you believe the main steam nozzle or the
Steam Blaster nozzle is clogged, please contact
Customer Service at 0800 862 0453 or
sharkclean.eu.
s h a r kc l e a n . e u
16