Yakima 8000226 Guia De Inicio Rapido página 3

Carefully blow
away debris.
Engage cap with screw.
Do not tighten fully.
A helpful friend will
make this easier.
1033033A-3/12
Apply a silicone bead
around the holes.
NOTE:
Due to manufacturing variances,
shell thickness can differ
considerably. You may need to
eliminate spacer or obtain longer
bolts from your local hardware
store. Use a stainless steel,
sockethead 10-32 bolt in the
desired length).
Attach Control Towers and
finish tightening bolts.
WARNING: Direct contact of
uncured sealant irritates eyes
and may irritate skin.
Overexposure to vapor may
irritate eyes, nose and throat.
Avoid eye and skin contact. Use
with adequate ventilation. Do
not handle contact lenses with
sealant on hands. In case of
eye contact, flush with water
for 15 minutes. Obtain medical
attention. In case of skin
contact, remove from skin and
flush with water. Sealant
releases acetic acid (vinegar-
like odor) during cure.
Push down and fully
tighten Towers.
Take off Towers and assemble
Landing Pads.
• Attach rubber pads.
Bolt
Washer
Spacer
Nylon
washer
Install assembled Landing Pads into holes.
Firmly close covers
until both sides snap.
" S N A P "