Setting Up - Tronic TCA 3 A1 Instrucciones De Uso

Setting up

ATTENTION
The total power consumption of the devices connected to all the USB
►
sockets
socket
2 .4 A . Refer to the instruction manual of your device for more
information .
The maximum power output of all the USB sockets
►
The maximum power output of each USB socket
Connect the car charger adapter to the 12/24 V connection of your
♦
car . This is usually the vehicle socket (cigarette lighter) on the dash-
board of your vehicle . Many vehicles have a second socket by the rear
seats or in the boot . 24 volt batteries are sometimes used in vehicles
such as lorries or boats .
The operating LED
♦
adapter is being supplied with power . The operating LED
up if no device is connected . Depending on the vehicle type, it is
possible that the ignition has to be switched on first .
Connect your device to the car charger adapter . For USB devices,
♦
use the original USB cable of your device for optimal charging .
If you need to, you can switch on your connected device and continue
♦
using it .
NOTE
Monitor the charging status on your connected device .
►
TCA 3 A1
_373026_TCA3A1_LB8.indb 7 _373026_TCA3A1_LB8.indb 7
may not be higher than 3 .4 A . For each individual USB
3
the current consumption of your device must not exceed
3
lights up white to signal that the car charger
1
together is 3 .4 A .
3
is 2 .4 A .
3
also lights
1
GB │ IE │
7 ■
01.09.2021 14:17:18 01.09.2021 14:17:18