Makita 2704 Manual De Instrucciones página 13

ACCESSORIES
CAUTION:
• These accessories or attachments are recom-
mended for use with your Makita tool specified in
this manual. The use of any other accessories or
attachments might present a risk of injury to per-
sons. Only use accessory or attachment for its
stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita service center.
Dado head set (Part No. 191794-9)
1
2
A dado is cutting a rabbet or a wide groove into the work-
piece. The dado head set consists of two outside cutters,
five inside cutters and paper washers.
• Outside cutters: 6"diameter, 1/8" thick, 5/8"arbor
hole, 2 pcs.
• Inside cutters: 6"diameter, 1/8"thick, 5/8"arbor hole,
4 pcs.
• Inside cutter: 6"diameter, 1/16"thick, 5/8"arbor hole,
1 pc.
• Paper washers: 5/8"arbor hole, 6 pcs.
Various combinations of these cutters are used to cut
grooves from 1/8" to 13/16" for use in making joints, ten-
oning, grooving, etc.
Table insert (Part No. 317934-3)
When cutting grooves, use this table insert instead of the
standard table insert.
To install the dado head set, proceed as follows:
1. Turn the tool off and unplug it before installing.
2. Remove the blade guard with the spreader.
3. Install the dado head set with the teeth pointing
down at the front of the table.
006174
1. Inside cutter
2. Outside cutter
006176
4. Use the chart below to select the proper cutters to
obtain the various cutting widths.
13