Main Broom Height Check And Adjustment - Nilfisk Advanced Terra 4300B Instrucciones De Uso

ENGLISH

MAIN BROOM HEIGHT CHECK AND ADJUSTMENT

NOTE
Brooms of various hardness are available. This
procedure is applicable to all types of brooms.
1. Check the main broom distance from the floor as shown
below:
• Drive the machine on a level floor.
• Keep the machine stationary, lower the main broom
and turn it on for a few seconds.
• Stop and lift the main broom, then move the machine
and switch it off.
• Check that the main broom print (A, Fig. 2), along its
length, is 0.8 to 1.6 in (2 to 4 cm) wide.
If the print (A) is not within specifications, adjust the broom
height as shown in step 2.
2. Engage the parking brake.
3. Turn the ignition key (72) to "0".
4. Open the hood (7).
5. Loosen the knob (A, Fig. 3) on the left side of the machine.
6. Turn the knob (B), and remind that:
• It must be screwed to lift the broom;
• It must be unscrewed to lower the broom.
After the adjustment, hold the knob (B) and tighten the
knob (A).
7. Perform step 1 again to check the proper adjustment of the
main broom height.
8. When the broom is too worn out the adjustment is no more
possible; replace the broom according to the instructions in
the next paragraph.
CAUTION!
If the main broom print is excessive [larger than
1.6 in (4 cm)], the machine regular operation is
affected and the moving or electrical parts can
overheat, thus reducing machine life.
Pay careful attention when performing the above-
mentioned checks, and always use the machine
according to the indicated conditions.
18
INSTRUCTIONS FOR USE
Terra™ 4300B - 1464035000
2 - 4 cm
0,8 - 1,6 in
Figure 2
A
B
Figure 3
A
S311389
S311390
06/2009