Logging Into The Web Application; Using The Web Application; Opening And Operating The Web Application; Establish Connection - Porsche PWCCU192 Serie Manual Del Usuario

Operation

Charging current limiting

The maximum available charging current is deter-
mined by the rotary switch setting and is set during
installation by the qualified electrician. The charger
detects the voltage and the available electric current
automatically.
The charging current can also be reduced by other
electrical loads in the home network, e.g. by an elec-
tric heater or water heater. If you are unsure about
this, contact a qualified electrician.
The power to be used for charging can be set us-
ing charging current limiting (Settings
charging current). The last charging current set is
saved. The charging power must never be set higher
than the maximum available power of the electrical
circuit used. If the charger is connected to an energy
manager, the energy manager limits the charging
current in accordance with the values set in the en-
ergy manager.

Logging into the web application

For standard operation of the web application, use
the Home user profile. The Customer service profile
has additional setting options and is intended for use
by your authorized Porsche dealer.
b Access data is to hand.
1. In the User field, select the corresponding user.
2. Enter password (from the letter containing ac-
cess data).
Information
After 25 minutes of inactivity, the user is automati-
cally logged off from the web application.
26
Opening the web application
Further configuration options and detailed informa-
tion about the previous charging processes can be
displayed using a Web Application, which is specific
to each charger.
For information on the Web Ap-
plication, refer to the instructions
at https://www.porsche.com/international/about-
porsche/e-performance/help-and-contact/
For other languages, select the desired country ver-
sion of the website.
e Adjust
Information
−
Depending on which browser you are using, the
Web Application will not open immediately; in-
stead information about the browser's security
settings will be displayed first.
−
The manner of entering the network key for call-
ing up the Web Application depends on the end
device's operating system.
Opening the web application via the hotspot
The Web Application can be opened using an end
device (PC, tablet or smartphone) via a hotspot set
up by the charger.
To set up a hotspot:
e
Refer to chapter "Hotspot" on page 22.
e
To open the Web Application while a hotspot
is active, enter the following IP address in the
browser's address line: 192.168.0.1
Opening the web application via WiFi
The Web Application can be called up in the browser
on a device (PC, tablet or smartphone) that is logged
into the same home network as the charger.
e
Enter the current IP address of the charger in the
browser's address line. You will find the current
e Network e Net-
IP address under Settings
work information.
– or –
Enter the host name of the charger in the brows-
er's address line. You will find the host name in
the letter containing access data.

Using the web application

Opening and Operating the Web
Application
Establishing a Connection to the Charger
If the charger was integrated in your existing home
network (WiFi or Powerline Communication) during
setup, it is possible to access the Web Application
using the assigned IP address.
For information on establishing network connections
g Refer to chapter "Connections" on page 28..
Opening the web application via WiFi
b The end device and the charger are in the same
WiFi network.
1. Open the browser.
2. In the address bar of the browser: enter the
IP address assigned during configuration (under
Settings e Networks e Network information on
the charger), or the host name of the charger
(provided in the letter containing access data).