Publicidad
Idiomas disponibles
Idiomas disponibles
21. Remove the retaining screws (1) securing the
grille (texture) to the grille surround.
22. Locate the sixteen tabs (2) securing the grille
surround to the grille (texture) and carefully
release all sixteen tabs (2).
23. Remove the produciton grille (texture) from the
surround/fascia and discard.
24. Locate the four fastener locations (1) and
postion the four bushings (C) in place.
25. Position the kit supplied grille (texture) to the
grille surround and align the sixteen mounting
tabs (2). Using hand pressure on the outside of
the grille surround and inside the grille (texture),
push together firmly to seat each mounting tabs (2).
A click/snap sound is normal when installing.
26. Look from the rear of the fascia, inspect and verify
that all mounting tabs (2) are seated properly.
27. Install the grille (texture) retaining screws (1) and
supplied washers (B). Tighten the fasteners
securely.
5/25/2011
Page 6 of 30
K6860996
Publicidad
