Mounting; Electrical Installation - SICK WSE26 Instrucciones De Operación

4

Mounting

5

Electrical installation

8020358.19RH / 15.01.2021 | SICK
Subject to change without notice
WEO26x-xxxxxx30
1
6
3 2
BluePilot blue: alignment aid
1
LED indicator yellow: status of received light beam
2
LED indicator green: supply voltage active
3
Press-turn element: time function adjustment
4
Teach pushbutton: adjustment of light/dark switching
5
Teach-Button: adjusting the sensitivity
6
Mount sensors (sender and receiver) using suitable mounting brackets (see the SICK
range of accessories). Align the sender and receiver with each other.
NOTE
When mounting multiple through-beam photoelectric sensors next each other, swap
the arrangement of the sender (WS26) and receiver (WE26) for every second pair.
Also maintain a sufficiently large distance between the pairs based on the light spot
diameter of the sender (WS26), see
Sender (WS)
Receiver (WE)
Sender (WS)
Figure 1: Arrangement of multiple through-beam photoelectric sensors
Note the sensor's maximum permissible tightening torque of < 1,3 Nm.
The sensors must be connected in a voltage-free state. The following information must
be observed, depending on the connection type:
– Male connector connection: Note pin assignment
– Cable: wire color
Only supply/switch on the voltage once all electrical connections have been estab‐
lished.
WEO26x-xxxxxx31
5
1
6
3 2
figure 1.
MOUNTING
WEO26x-xxxxxx32
4
1
6
3 2
Receiver (WE)
Sender (WS)
Receiver (WE)
4
5