Powers P180 Manual De Instrucciones página 24

24 English
Operation 18V BATTERY CHARGER
Appropriate batteries
EN
18V BATTERY
LI battery with a rated voltage of
10.8 - 18.0 V DC.
Charging the battery
Only put original batteries into the battery
charger!
Plug the charger into the mains.
The LED lights up green.
Push the battery into the charger as far as the
stop.
The battery is charging.
The battery is charged; the charger has
switched to trickle charge.
Unplug the charger from the mains if the
charger is unattended.
During the charging process, both the battery
and the charger heat up.
LED charge level indicator
Permanent green light without battery
The device is ready for operation, there is no bat-
tery in the charging compartment.
Flashing green light
Battery is charging.
Permanent green light
The battery is fully charged, the charger has
switched to trickle charge.
Quickly flashing green light
Battery is too hot or too cold.
The charging process begins automatically as
soon as the battery reaches a temperature within
the permissible range.
Short-circuiting between the charging contacts.
Remove the battery from the charger.
Pull the mains plug!
Check that there are no foreign bodies in the
charging compartment. Reinsert the battery.
Battery is faulty.
Akkuschrauber-EN / 1006
Use a new battery.
Operating the power tool
Removing the battery
To remove the battery 5, press the release but-
ton(s) VIII and pull the battery out of the power
tool.
Inserting the battery
Use only original Powers batteries with the volt-
age given on the type plate of your machine.
The use of other batteries can lead to injuries and
danger of fire.
Set the rotational direction switch V to the
middle position to prevent it being switched
on accidentally.
Insert the charged battery 5 into the handle
until you feel it click into place.
On/Off
Press or release the On/Off switch VI.
Changing the speed
The On/Off switch VI can be used for infinitely var-
iable speed control. Light pressure on the On/Off
switch VI causes the machine to rotate slowly;
with increased pressure, the speed increases.
Selecting the rotary direction
Only operate the rotational direction switch V
when the machine is at a standstill!
Set the required rotary direction.
Clockwise rotation:
For drilling and fixing screws.
Anticlockwise rotation:
For loosening and removing screws
and nuts.
Important! Always press the rotational direction
switch V up to the stop on the housing, i. e. until
you feel it engage.
When the rotational direction switch V is in its mid-
dle position, the machine cannot be switched on.
Setting the torque (Option)
You can set the desired torque in several steps
using the torque selection collet III. With the cor-
rect setting, the insert tool is stopped as soon as
Operation