Tools And Accessories; Special Accessories - Powers P180 Manual De Instrucciones

2 6 E n l g s i h
Clutch
The screw can be placed on the still standing bit
while the machine is running. The clutch engages
EN
only after applying pressure while screwing. When
the depth stop comes to rest on the surface, the
clutch is disengaged. The bit again comes to a
stop.
Thread cutting
We recommend the use of machine thread taps.
Lightly oil the thread tap.
Select low speed and 1st gear.
Cut in clockwise direction, stop, remove in
anticlockwise direction.
-NOTE-
Always work at low speed when thread cutting.
This prevents the thread tap breaking off.

5. Tools and accessories

When drilling metal, use only sharpened HSS drill
tips (HSS=High-Speed Steel) which are in perfect
condition.
Changing the tool holding fixture
Remove the battery from the device
before undertaking any work on the
device.
This safety measure prevents acciden-
tal starting of the power tool.
Observe the notes in the illustrated instructions.
Devices with QuiXS holder (Option)
QuiXS quick change system
Fitting the QuiXS chuck (Accessories)
Pull the unlocking ring VII back.
Fit the QuiXS chuck I onto the drill spindle up
to the stop 1 and release the unlocking ring
VII.
-NOTE-
The bit XI in the hexagon-shaped socket 2 can
remain in the drill spindle 1 while fitting the
chuck.
Akkuschrauber-EN / 1006
Removing the QuiXS chuck
Pull the unlocking ring VII back and remove
the QuiXS chuck I.
Fitting the QuiXS angle adapter (Acces-
sories)
Remove the bit XI from the hexagon-shaped
socket 2.
Fit the angle adapter XIII onto the drill spindle
1 and twist it until it engages in the desired
position.
-NOTE-
The angle adapter can be engaged in various
angle positions.
Lock the angle adapter XIII in position by
tightening the unlocking ring VII.
Removing the QuiXS angle adapter
Loosen the unlocking ring VII as far as the
stop.
Take off the angle adapter XIII.
Devices without QuiXS holder
On devices not equipped with a QuiXS holder,
have the chuck replaced by an authorised cus-
tomer service station.
(Option)
Belt clipholder
The belt clipholder 10 can be used to clip the pow-
er tool to a belt, for example. This leaves both your
hands free, while the power tool remains within
easy reach at all times.
You can also store up to 8 bits in the belt cliphold-
er.
To use the belt clipholder, proceed as follows:
Screw the retaining pin 11 to the power tool.
Place the belt clipholder in the desired posi-
tion.
Hook the power tool into the belt clipholder.

Special accessories

Do not use accessories made by other manufac-
turers, as these are not tested by Powers.
It can be dangerous to use such accessories.
To avoid injury and damage, use only accessories
recommended by Powers.
T o o s l a n d a c c e s s r o e i s