Technoline WS 9069 Manual Del Usuario página 7

Part A – Base station
A1: RCC icon
A4: Humidity
A7: Pool temperature
A10: SET button
A13: Hanging hole
Part B – Pool sensor
B1: Fastening eyelet
B3: Reception icon
Part C – Temperature sensor
C1: Reception icon
C3: Battery compartment
Initial operation

Place the base station, temperature sensor and pool sensor in front of you and open battery
compartment cover of each of them.

Insert 2 x AAA batteries into the base station while observing the correct polarity [ "+" and " –"
marks].

Insert 2 x AA batteries into the pool sensor while observing the correct polarity [ "+" and " –"
marks].

Insert 2 x AA batteries into the temperature sensor while observing the correct polarity [ "+"
and " –" marks].

Close the battery compartment of the base station, temperature sensor and pool sensor again.

The station will now start to make a connection to the outdoor temperature sensor and the
pool sensor. This operation takes about 3 minutes and is displayed by a flashing reception
icon in the "OUT TEMP" and "POOL TEMP" display area on the station.

After station has created a connection to the temperature sensor and the pool sensor, it will
A2: Time
A5: Outdoor temperature
A8: Pool reception icon
A11: MIN /MAX / RESET button
A14: Battery compartment
B2: Lock marking
B4: Pool temperature display
C2: Outdoor temperature display
C4: Stand
A3: Indoor temperature
A6: Outdoor reception icon
A9: MIN / MAX icons
A12: + button
A15: Stand
EN2