Publicidad
Idiomas disponibles
Idiomas disponibles
then enter the radio control time reception mode.
Note:
To manually start to find outdoor sensor signals, press the + button in normal display mode.
"LEARN" will flash in the corresponding area of temperature sensor or pool sensor on display
Environmental reception effects
The station obtains the accurate time with wireless technology. Same as all wireless devices, the
reception is maybe affected by the following circumstances:
long transmitting distance
nearby mountains and valleys
near freeway, railway, airports, high voltage cable etc.
near construction site
among tall buildings
inside concrete buildings
near electrical appliances (computers, TV's, etc) and metallic structures
inside moving vehicles
Place the station at a location with optimal signal, i.e. close to a window and away from metal
surfaces or electrical appliances.
Reception of the radio-controlled time signal:
The clock automatically starts the DCF signal search after 7 minutes of any restart or changing
of new fresh batteries. The radio mast (RCC) icon starts to flash.
At 1:00 / 2:00 / 3:00 / 4:00 / 5:00 the clock automatically starts the synchronization procedure
with the DCF signal to correct any deviations to the exact time. If this synchronization attempt
is unsuccessful (the radio mast icon disappears from the display), the system will automatically
attempt another synchronization at the next full one hour. This procedure is repeated
automatically up to total 5 times.
Notes:
A flashing radio mast icon indicates that the DCF signal reception has started
A continuously displayed radio mast icon indicates that the DCF signal was received
successfully
We recommend a minimum distance of 2.5 meters to all sources of interference, such as
televisions or computer monitors
Radio reception is weaker in rooms with concrete walls (e.g.: in cellars) and in offices. In such
circumstances, place the system close to the window.
Manual time setting
Press and hold the SET button to enter setting mode and "0h" is flashing. Press the + button to
adjust the value within the range of -2 to +5. The fitting time difference will be added when
displaying time, allowing the clock to use radio-controlled time in different time zones.
Press the SET button again, RCC is displayed and "ON" is flashing. Press the + button to
enable radio-controlled time with "ON" or disable it with "OFF". When set to OFF, the clock will
only use quartz clock.
Press the SET button again, "24h" is flashing. Press the + button to set 12 hour display mode
(12h) or 24 hour display mode (24h).
Press the SET button again, the hour digits are flashing. Press the + button to set the hour.
Press the SET button again, the minute digits are flashing. Press the + button to set the
minutes.
Press the SET button again, the "°C" is flashing. Press the + button to set temperature
EN3
Publicidad
