Before You Start The Device; Remote Control: How To Insert Or Change The Battery; Installation; General Installation Instructions - Silvercrest SKWH 2000 A2 Instrucciones De Utilización Y De Seguridad

3. Before you start the device

3.1 Remote control: How to insert or change
the battery
The remote control unit is delivered together
with a lithium button cell. To enable the remote
control, remove the plastic tape that protrudes
from the battery compartment
1
If the remote control battery needs to be
replaced, insert a new 3-volt lithium button cell.
Pay attention to the type of lithium button cell
(CR2025).
2
Press the tab on the battery compartment
12
of the remote control toward the centre. Now pull
out the battery compartment
Remove the old battery.
Insert a new 3V-button-cell battery (type
CR2025). Pay attention to the correct polarity.
Push the battery compartment
remote control unit until the tab
place.
14 GB/IE/NI/CY/MT

4. Installation

4.1 General installation instructions

Please note: Make sure that the wall can bear
(see Figure 1).
13
weights of at least 4.1 kg.
Please note: If necessary, you will need a climbing
aid (e.g. a ladder) to carry out the installation.
3
4
13
(see Figure 2).
13
back into the
13
snaps into
12
Hang the device onto the wall. The device's air
outlet G should be at the bottom Use the dow-
els J and screws I included in the delivery.
The distance between the holes must be 31.5 cm
(see Figure 3).
The distance to the ceiling and walls must be at
least 30 cm.
The distance to the floor must be at least 2 m
(see Figure 4).