Maintenance; Troubleshooting; Maintenance / Troubleshooting - Triton TPL 180 Instrucciones De Uso

MAINTENANCE

WARNING: Always ensure that the tool is switched off and
the plug is removed from the power point before making
any adjustments or maintenance procedures.
Regularly check that all the fixing screws are tight. They
may vibrate loose over time
Cleaning
1. Keep the tool's air vents unclogged and clean at all
times
2. Remove dust and dirt regularly. Cleaning is best done
with compressed air or a dry, soft to medium brush
like a paint brush
CAUTION: Wear protective goggles when cleaning the tool.
3. Re-lubricate all moving parts at regular intervals
4. Never use caustic agents to clean plastic parts
CAUTION: Do not use cleaning agents to clean the plastic
parts of the tool. A mild detergent on a damp cloth is
recommended. Water must never come into contact with
the tool. Ensure the tool is thoroughly dry before using it.

TROUBLESHOOTING

SYMPTOM
No power
Motor does not start
Rough finish on wood after planing
GB
Depth of cut incorrect
Barrel not rotating
Vibration or abnormal noise

Maintenance / Troubleshooting

10
Brushes
• Over time the carbon brushes inside the motor may
become worn
• Excessively worn brushes may cause loss of power,
intermittent failure, or visible sparking
• If you suspect that the brushes may be worn, have
them replaced at an authorised service centre
Power cord maintenance
If the supply cord needs replacing, the task must be carried out
by the manufacturer, the manufacturer's agent, or a qualified
electric service repairer in order to avoid a safety hazard
Disposal
Always adhere to national regulations when disposing
of power tools that are no longer functional and are not
viable for repair.
• Do not dispose of power tools, or other waste electrical
and electronic equipment (WEEE), with household waste
• Contact your local waste disposal authority for information
on the correct way to dispose of power tools
POSSIBLE CAUSE
Mains plug not inserted into socket or
switched on
Fuse blown in plug or circuit breaker
tripped in consumer unit
RCD connected and not reset
Extension lead overloaded and thermal
protection has operated
Power lead or power lead connection to
tool or mains plug damaged
Power tool fault
Carbon brushes worn
Power tool fault
Worn blade or blades
Damaged blade or blades
Wood is wet
Worn or damaged blades
Poorly fitted blade or blades
Incorrect blades fitted
Broken drive belt
STOP using tool immediately
SOLUTION
Plug in and switch on
Replace fuse or reset circuit breaker
Reset
Replace extension lead or unwind cable
fully from reel to allow maximum current
use and reset reel thermal protection
Requires repair at an authorised Triton
service centre
Requires repair at an authorised Triton
service centre
Brushes need replacing by an authorised
Triton service centre
Requires repair at authorised Triton service
centre
Replace all blades
Replace one or more blades
Allow wood to dry
Replace blades
Re-fit blade or blades
Replace blades with correct type
Replace belt
Re-check all user accessible parts are
secure and correctly fitted first and if not
solved contact an authorised Triton service
centre