SEA FIELD Manual De Instrucciones página 7

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
6.4. Unscrew the nuts A and B, turn the cam with the counter-
connecting rod until it reaches the stop and relock the nuts
(Fig. 28)
Fig. 28
In case of a not perfect positioning of the leaves in opening, it
is possible to adjust the position through the cam.
Close the operator with the cover using the 4 enclosed screw.
After ending all the operations in the installation of the above
mentioned carrying box, of the gate and the operator, try to do
some moves slowly by hand verifying that there are not
irregular frictions and that the movement is uniform for the
whole range.
Notice: to do this last operation, release the operator as
described in the next paragraph.
When putting in function the installation it is peremptory to
lubricate the box as in Fig. 11 until the grease comes out.
grease type DIN 51502 KP 2 N-20 - K 2 K-20).
7. CABLE LAYOUT
Fig. 29
2
3
1) Warning notice
2) Field operator 5) Key switch
3) Left photocell
6) Antenna
4) Right photocell
7) Flashing lamp
14 cod. 67410630
®
A
B
Stop
(Fig. 29)
7
6
1
5
4
2
8) Control board
9) Receiver
10) 16A-30mA differential switch
To the attention of users and technicians
8. RELEASE SYSTEM
RELEASE
8.1. To release act as follows:
- Insert the enclosed key into the keyhole (S) and turn the
handle about 180° against the centre of the gate (Fig. 30) .
- Keep the key locked and move the leaf, now turn back the
key to the normal position and extract it.
8.2. To stop again act as follows:
- Move the leaf until the lock has coupled again.
Fig. 30
RELEASE PLUS
8.3. To release act as follows:
- Insert the enclosed key into the keyhole and turn it about 90°
in clockwise direction (Fig. 31).
- Pull the key against the external of the release making come
out the handle of the lock until it reaches the stop (Fig.32).
- Move the leaf and make return the handle of the release in
its original position and extract the key.
(U se
8.4. To stop again act as follows:
- Move the leaf until the lock has coupled again.
Fig. 31
8
9
10
Fig. 32
Rev 12 - 03/2011
ENGLISH
90°
Release handle
Stop