Configuring Dccs Camera; For A Ptz Camera; For A Zoom Lens Control Camera - IVS System AVD744C Manual Del Usuario

3) In "CONNECTION", it shows the examining result for DCCS signal transmission between the DVR and
camera. The message is as follows:
MESSAGE SHOWN
CHECKING
OK
FAIL

2.10 Configuring DCCS Camera

DCCS cameras have three types: PTZ cameras, zoom lens control cameras, and human detection cameras.
Based on the camera type, different camera settings are needed as described below.
Note: iPhone Push Notification is available only when a human detection camera is connected properly
to the correct channel which supports DCCS. For iPhone Push Notification to work properly, please
refer to "APPENDIX 1. SET IPHONE PUSH NOTIFICATION" at page 15.

2.10.1 For a PTZ camera

Switch to the channel which connects to your PTZ camera, and click "
display the PTZ control panel.
Configure the camera by clicking "

2.10.2 For a zoom lens control camera

In the "DCCS" menu, move to the channel which connects to the zoom lens control camera, and click
"SETUP" in "MENU".
CANERA
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
DEVICES
DCCS
IVS
NOTIFY
EXIT
Different zoom lens control cameras might have different parameter settings. For details, please refer to
their own user manuals.
MEANING
The DVR is checking the DCCS signal transmission between the DVR
and camera.
The signal transmission is fine and the DCCS function works properly.
The signal transmission is too weak or not available for the DCCS
function to work properly.
ADVANCED CONFIG
CH1 CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11
DIAGNOSTIC
MENU
DEVICE
CONNECTION
". For camera configuration details, please refer to its user manual.
START
SETUP
AVK523
OK
6
" on the quick menu bar to